Engineering Hotline
Free Engineering Advice
Call 1-888-89-STAMP
Spending time you don't have on your connector design? Have a few wild ideas that you would like to run past someone that specializes in stamping design? Our engineers will help answer your questions or walk you through the design process.
What do you call your CEC?
Custom Engineered Components aka Metal Component PartsThe components on these lists are typically made using a precision metal stamping process. In fact, if it made out of thin metal, and is less than 4 inches wide, 4 inches long, and 1/2 inch high, it should be stamped.
Do you recognize these products using these terms? If you call them some thing else, or you know of some CECs we have missing from our list, we would love to hear from you so that we may keep our list up to date and comprehensive. Send your comments directly to our marketing manager: pkdennis@die-tech.com.
Contacts:
crimp-to-wire contacts
vertical receptacles contacts
horizontal receptacles contacts
shrouded header contacts
unshrouded header contacts
battery contacts
contact receptacle
brush contacts
shielded contacts
coax contacts
Connectors:
board to board connectors
wire to board connectors
cable to board connectors
wire to wire connectors
board to cable connectors
board to backplane connectors
board in connectors
panel detachable connectors
backplane connectors
card edge connectors
FPC connectors
flexible power cable connectors
PCB connectors
printed circuit board connectors
cabled power connectors
power connectors
VRM connectors
appliance connectors
power key connectors
flexible conduit connectors
flexible circuit to board connectors
cable connectors
grounding connectors
storage connectors
memory card connectors
RF connectors
microwave connectors
sealed connectors
discrete wire connectors
circular connectors
filter connectors
fiber optic connectors
hermetic connectors
rectangular connectors
board level connectors
rigid flex connectors
ground plane connectors
reverse bayonet coupling connectors
heavy-duty connectors
ribbon cable connectors
Crimps:
wire crimps
Frames:
Heatsinks:
Interconnects:
consumer interconnects (I/O)
cable interconnects
battery interconnects
bus bar interconnects
high performance interconnects
board to backplane interconnects
Jumpers:
Leads:
I/O leads
surface mount leads
Leadframes:
edge clip leadframe
SIP (single in-line package) leadframe
DIP (dual in-line package) leadframe
J-clip leadframe
reverse J-clip leadframe
surface mount leadframe
solder laden leadframe
ZIP leadframe
thru-hole leadframe
quad flat pack leadframe
Lids:
Pins:
unshrouded header pins
shrouded header pins
latch header pins
shunt pins
Rings:
retaining rings
shield rings
Spades:
wire spades
Splices:
closed end splices
crimpband splices
Sockets:
tube sockets
Substrates:
aluminum substrates
Tabs:
microwave tabs
RF tabs
Terminals:
automotive terminals
terminal blocks
barrel terminals
filter terminals
fiber optic terminals
Traps:
wire traps
Free Reports
Demystifying the Supply Chain: Understanding Cycles
Building the Prototype From Concept to Production
How to avoid mistakes & failed projects -- download this critical report now!
Quick Contact
Die-Tech
295 Sipe Road
York Haven, PA 17370
Phone: 717-938-6771
Get Directions